The PZL P.6 was a pre-WW2 Polish single-seat gull-wing monoplane fighter, designed by Zygmunt Puà Âawski, and manufactured by the Paà Âstwowe Zakà Âady Lotnicze (PZL) state-owned factory. It remained a prototype and did not go into production.
Zygmunt Puà Âawski designed the all-metal metal-covered monoplane PZL P.1 fighter in 1928 which was powered with an inline engine, and developed a speed of , but remained a prototype, because the Polish Air Force decided that its fighters should be powered with a Polish-built radial engine. The next model PZL P.6, was powered with a Bristol Jupiter VI FH radial engine.
The PZL P.6 flew for the first time in August 1930 with test pilot Bolesà Âaw Orlià Âski at the controls. It had a very similar wing to the P.1, but the semi-monocoque fuselage was completely redesigned with an circular cross-section, and the tail was altered. The modifications reduced the aircraft's empty weight by over .
The PZL P.6 was an all-metal duralumin-covered, strut-braced, gull-wing monoplane. The forward fuselage was built around a tubular steel frame, while the rear fuselage was a circular semi-monocoque. The tapered two-spar wing which was thinner and narrower at the root was skinned with a ribbed and corrugated Wibault type duralumin sheet, and braced by a pair struts on either side. The open cockpit was provided with a windscreen but no headrest. The Bristol Jupiter VI FH radial engine mounted in front was fitted with a Townend ring to reduce drag and used a fixed pitch two-bladed metal propeller. Puà Âawski abandoned the single strut internally sprung legs of the P.1, and used a pair of vees, each braced to the centerline. The fixed undercarriage with a rear skid was conventional and typical of the period. The fuselage had a fuel tank that could be jettisoned in case of an emergency.
The wing design was referred to as the "Polish wing" or "Puà Âawski wing" although it was preceded by the Nieuport Madon, which used the exact same configuration. During a presentation at the Paris Air Show in Le Bourget in December 1931, the aviation press, such as L'Air, The Aeroplane, Flight and Die Luftwacht acknowledged the P.6 as one of the world's top fighter designs. Significantly, the P.6 prototype, piloted by Bolesà Âaw Orlià Âski, won the American National Air Races held in Cleveland between the 29th of August and the 7th of September 1931.
The PZL P.6 did not enter production, because at the same time the next improved variant, the PZL P.7 was being developed. The first P.7 prototype retained most design traits of the P.6 with a more powerful supercharged Bristol Jupiter VII F engine, and achieved better performance at higher altitudes.
The single P.6 prototype crashed on 11 October 1931 near CzÃÂstochowa due to the propeller breaking apart, resulting in catastrophic engine failure. The pilot bailed out successfully.