Oxygenated treatment (OT) is a technique used to reduce corrosion in a boiler and its associated feedwater system in flow-through boilers.
With oxygenated treatment, oxygen is injected into the feedwater to keep the oxygen level between 30 and 50 ppb. OT programs are most commonly used in supercritical (i.e. >3250psi) power boilers. The ability to change an existing sub-critical boiler over to an OT program is very limited. "Common injection points are just after the condensate polisher and again at the deaerator outlet." This forms a thicker protective layer of hematite (Fe<sub>2</sub>O<sub>3</sub>) on top of the magnetite. This is a denser, flatter film (vs. the undulation scale with OT) so that there is less resistance to water flow compared to AVT. Also, OT reduces the risk of flow-accelerated corrosion.
When OT is used, conductivity after cation exchange (CACE) at the economiser inlet must be maintained below 0.15üS/cm this can be achieved by the use of a full-flow condensate polisher.