The ClausiusâÂÂClapeyron relation, in chemical thermodynamics, specifies the temperature dependence of pressure, most importantly vapor pressure, at a discontinuous phase transition between two phases of matter of a single constituent. It is named after Rudolf Clausius and Benoît Paul ÃÂmile Clapeyron. However, this relation was in fact originally derived by Sadi Carnot in his Reflections on the Motive Power of Fire, which was published in 1824 but largely ignored until it was rediscovered by Clausius, Clapeyron, and Lord Kelvin decades later. Kelvin said of Carnot's argument that "nothing in the whole range of Natural Philosophy is more remarkable than the establishment of general laws by such a process of reasoning."
Kelvin and his brother James Thomson confirmed the relation experimentally in 1849âÂÂ50, and it was historically important as a very early successful application of theoretical thermodynamics. Its relevance to meteorology and climatology is the increase of the water-holding capacity of the atmosphere by about 7% for every 1 ðC (1.8 ðF) rise in temperature.
On a pressureâÂÂtemperature (PâÂÂT) diagram, for any phase change the line separating the two phases is known as the coexistence curve. The Clapeyron relation gives the slope of the tangents to this curve. Mathematically,
where is the slope of the tangent to the coexistence curve at any point, is the molar change in enthalpy (latent heat, the amount of energy absorbed in the transformation), is the temperature, is the molar volume change of the phase transition, and is the molar entropy change of the phase transition. Alternatively, the specific values may be used instead of the molar ones.
The ClausiusâÂÂClapeyron equation applies to vaporization of liquids where vapor follows ideal gas law using the ideal gas constant and liquid volume is neglected as being much smaller than vapor volume V. It is often used to calculate vapor pressure of a liquid.
where N is the amount of substance and n is the number density. The equation expresses this in a more convenient form just in terms of the latent heat, for moderate temperatures and pressures.
Suppose two phases, and , are in contact and at equilibrium with each other. Their chemical potentials are related by
Furthermore, along the coexistence curve,
One may therefore use the GibbsâÂÂDuhem relation
(where is the specific entropy, is the specific volume, and is the molar mass) to obtain
Rearrangement gives
from which the derivation of the Clapeyron equation continues as in the previous section.
When the phase transition of a substance is between a gas phase and a condensed phase (liquid or solid), and occurs at temperatures much lower than the critical temperature of that substance, the specific volume of the gas phase greatly exceeds that of the condensed phase . Therefore, one may approximate
at low temperatures. If pressure is also low, the gas may be approximated by the ideal gas law, so that
where is the pressure, is the specific gas constant, and is the temperature. Substituting into the Clapeyron equation
we can obtain the ClausiusâÂÂClapeyron equation
for low temperatures and pressures, where is the specific latent heat of the substance. Instead of the specific, corresponding molar values (i.e. in kJ/mol and = 8.31 J/(molâ K)) may also be used.
Let and be any two points along the coexistence curve between two phases and . In general, varies between any two such points, as a function of temperature. But if is approximated as constant,
or
These last equations are useful because they relate equilibrium or saturation vapor pressure and temperature to the latent heat of the phase change without requiring specific-volume data. For instance, for water near its normal boiling point, with a molar enthalpy of vaporization of 40.7 kJ/mol and = 8.31 J/(molâ K),
In the original work by Clapeyron, the following argument is advanced. Clapeyron considered a Carnot process of saturated water vapor with horizontal isobars. As the pressure is a function of temperature alone, the isobars are also isotherms. If the process involves an infinitesimal amount of water, , and an infinitesimal difference in temperature , the heat absorbed is
and the corresponding work is
where is the difference between the volumes of in the liquid phase and vapor phases. The ratio is the efficiency of the Carnot engine, . Substituting and rearranging gives
where lowercase denotes the change in specific volume during the transition.
For transitions between a gas and a condensed phase with the approximations described above, the expression may be rewritten as
where are the pressures at temperatures respectively and is the ideal gas constant. For a liquidâÂÂgas transition, is the molar latent heat (or molar enthalpy) of vaporization; for a solidâÂÂgas transition, is the molar latent heat of sublimation. If the latent heat is known, then knowledge of one point on the coexistence curve, for instance (1 bar, 373 K) for water, determines the rest of the curve. Conversely, the relationship between and is linear, and so linear regression is used to estimate the latent heat.
Atmospheric water vapor drives many important meteorologic phenomena (notably, precipitation), motivating interest in its dynamics. The ClausiusâÂÂClapeyron equation for water vapor under typical atmospheric conditions (near standard temperature and pressure) is
where
The temperature dependence of the latent heat can be neglected in this application. The AugustâÂÂRocheâÂÂMagnus formula provides a solution under that approximation:
where is in hPa, and is in degrees Celsius (whereas everywhere else on this page, is an absolute temperature, e.g. in kelvins).
This is also sometimes called the Magnus or MagnusâÂÂTetens approximation, though this attribution is historically inaccurate. But see also the discussion of the accuracy of different approximating formulae for saturation vapour pressure of water.
Under typical atmospheric conditions, the denominator of the exponent depends weakly on (for which the unit is degree Celsius). Therefore, the AugustâÂÂRocheâÂÂMagnus equation implies that saturation water vapor pressure changes approximately exponentially with temperature under typical atmospheric conditions, and hence the water-holding capacity of the atmosphere increases by about 7% for every 1 ðC rise in temperature.
One of the uses of this equation is to determine if a phase transition will occur in a given situation. Consider the question of how much pressure is needed to melt ice at a temperature below 0 ðC. Note that water is unusual in that its change in volume upon melting is negative. We can assume
and substituting in
we obtain
To provide a rough example of how much pressure this is, to melt ice at âÂÂ7 ðC (the temperature many ice skating rinks are set at) would require balancing a small car (mass ~ 1000 kg) on a thimble (area ~ 1 cm<sup>2</sup>). This shows that ice skating cannot be simply explained by pressure-caused melting point depression, and in fact the mechanism is quite complex.
While the ClausiusâÂÂClapeyron relation gives the slope of the coexistence curve, it does not provide any information about its curvature or second derivative. The second derivative of the coexistence curve of phases 1 and 2 is given by
where subscripts 1 and 2 denote the different phases, is the specific heat capacity at constant pressure, is the thermal expansion coefficient, and is the isothermal compressibility.